Canon-imageRUNNER-3045 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3045 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3045 E003 0000 Error Code
E003 0000
Description :
The fixing temperature is too low after a standby state.
Causes :
While regular temperature control is under way, the reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1293-020 Fuser (Fixing) Unit – 120 Volt (Genuine) – $599.95
Canon imageRUNNER 3045 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 3045 E000, E001, E002, E003, Error Code Reset
If you’re looking over this piece of content and have exposure to this fault and desire to make a contribution make sure you leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have exposure to the problem then I will reply.
Remember, not every error is absolutely identical. What fixes the situation one time might not get rid of it the next occasion. While the material in this text is inspired by the service manual and most likely should get your equipment ready to go, from time to time additional variables might be in play.
