Canon-imageRUNNER-3035 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3035 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3035 E248 0000 Error Code
E248 0000
Description :
The backup memory is faulty.
Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up
Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.
If you’re looking over this blog post and have exposure to this fault and would like to share please make sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have knowledge about the problem then I will reply.
Remember that, not every error is completely identical. What treats the difficulty one time might not exactly solve it the next occasion. While the details in this page is obtained from the service manual and in most cases should get your unit ready to go, occasionally additional variables can be in play.
