Canon-imageRUNNER-3035 E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3035 E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3035 E002 0000 Error Code
E002 0000
Description :
The rise in temperature of the fixing assembly is faulty.
Causes :
While startup control is under way, the reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
While startup control is under way, the reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1293-020 Fuser (Fixing) Unit – 120 Volt (Genuine) – $599.95
Canon imageRUNNER 3035 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 3035 E000, E001, E002, E003, Error Code Reset
If you’re looking at this write-up and have knowledge about this fault and would wish to contribute you should leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have experience with the issue then I will reply.
Realize, not every error is totally alike. What corrects the issue one occasion may possibly not eliminate it the next occasion. While the advice in this writing originates from the service manual and normally should get your product operating, occasionally other variables might be in play.
