Canon-imageRUNNER-3030 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3030 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3030 E261 0000 Error Code
E261 0000
Description :
The zero-cross signal is faulty.
Causes :
When the relay is on, the zerocross signal is not detected for 500 msec or more.
Solutions :
Replace the AC driver PCB.
Replace the DC controller PCB.
If you’re looking at this post and have experience with this fault and want to share please make sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will answer back.
Realize, not every error is absolutely alike. What remedies the problem one occasion will possibly not solve it the next time. While the data in this page is obtained from the service manual and most likely should get your equipment operating, from time to time additional variables could possibly be in play.
