Canon-imageRUNNER-3030 E248 0000 Error Code

 

Canon-imageRUNNER-3030 E248 0000 Error Code Instructions

Below you will find the service manual information for the Canon-imageRUNNER-3030 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon-imageRUNNER-3030 E248 0000 Error Code

Service Manual Instructions for the Canon-imageRUNNER-3030 E248 0000 Error Code

E248 0000
Description :
The backup memory is faulty.

Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up


Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.


If you’re looking at this piece of content and have knowledge of this error and wish to contribute make sure you leave a comment down the page. Or, if you have read this article and have further questions then ask. If I have information about the issue then I will answer.

Please remember, not every error is totally the same. What fixes the difficulty one time might not exactly get rid of it the next time. While the help and advice in this blog hails from the service manual and oftentimes ought to get your piece of equipment ready to go, sometimes additional circumstances might be in play.

We will be happy to hear your thoughts

Leave a reply

Shopping cart