Canon-imageRUNNER-3025 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-3025 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-3025 E248 0000 Error Code
E248 0000
Description :
The backup memory is faulty.
Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up
Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.
If you are reading this page and have knowledge about this fault and would wish to contribute make sure you leave a comment down below. Or, if you have read this article and have more questions then ask. If I have information about the situation then I will answer back.
Make sure you remember, not every error is entirely alike. What corrects the problem one occasion might not eliminate it the next time. While the information in this page originates from the service manual and most likely should get your device up and running, at times other variables might be in play.
