Canon-imageRUNNER-2830 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-2830 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-2830 E261 0000 Error Code
E261 0000
Description :
The zero-cross signal is faulty.
Causes :
When the relay is on, the zerocross signal is not detected for 500 msec or more.
Solutions :
Replace the AC driver PCB.
Replace the DC controller PCB.
If you are looking over this page and have exposure to this fault and would wish to share please be sure to leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will reply.
Don’t forget, not every error is entirely alike. What remedies the trouble one time may possibly not take care of it the next time. While the content in this document is obtained from the service manual and oftentimes should get your piece of equipment working, at times additional circumstances may be in play.
