Canon-imageRUNNER-2830 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-2830 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-2830 E248 0000 Error Code
E248 0000
Description :
The backup memory is faulty.
Causes :
[Cause] A check error has occurred on the backup SRAM board.
[Location] bottom ROM
[Timing of Detection] once when the boot ROM is started up
Solutions :
1. Check the presence/absence of a backup SRAM PCB.
2. Disconnect and then connect the backup SRAM PCB.
3. Replace the backup SRAM PCB with a new one.
If you are looking over this page and have expertise in this error and want to make a contribution be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will respond.
Don’t forget, not every error is completely the same. What remedies the complication one time might not exactly resolve it the next occasion. While the material in this blog post obtain from the service manual and most likely should get your piece of equipment functioning, from time to time other elements might be in play.
