Canon-imageRUNNER-2270 E007 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-2270 E007 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-2270 E007 0000 Error Code
E007 0000
Description :
The rotation of the fixing film is faulty.
Causes :
While the fixing motor is rotating, the marker signal is not detected for 6 sec with the reading of the main thermistor indicating 100 deg C or more.
Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.
Canon FM3-1278-000 Fuser (Fixing) Unit – 120 Volt (Genuine) – $549.95
Canon imageRUNNER 2270 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000
Canon imageRUNNER 2270 E000, E001, E002, E003, Error Code Reset
If you are looking at this piece of content and have knowledge of this error message and want to contribute please leave a comment down below. Or, if you have read this article and have more questions then ask. If I have information about the situation then I will answer back.
Bear in mind, not every error is completely the same. What corrects the difficulty one time may possibly not take care of it the next occasion. While the material in this page obtain from the service manual and most often should get your piece of equipment working, at times additional factors may be in play.
