Home » Canon Repair Articles » Canon-imageRUNNER-2270 E002 0000 Error Code

Canon Repair ArticlesimageRUNNER 2270

Canon-imageRUNNER-2270 E002 0000 Error Code

admin

May 12, 2017

5 Views 0

SaveSavedRemoved 0

Canon-imageRUNNER-2270 E002 0000 Error Code Instructions

Below you will find the service manual information for the Canon-imageRUNNER-2270 E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Service Manual Instructions for the Canon-imageRUNNER-2270 E002 0000 Error Code

E002 0000
Description :
The rise in temperature of the fixing assembly is faulty.

Causes :
While startup control is under way, the reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
While startup control is under way, the reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.

Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.

Canon FM3-1278-000 Fuser (Fixing) Unit – 120 Volt (Genuine) – $549.95

If you are looking at this piece of content and have knowledge about this problem and want to make a contribution make sure you leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have information about the situation then I will reply.

Bear in mind, not every error is completely the same. What corrects the complication one time may possibly not fix it the next time. While the ideas in this blog post is obtained from the service manual and most often ought to get your device ready to go, now and again additional circumstances may be in play.