Canon-imageRUNNER-2230 E743 0000 Error Code Instructions
Below you will find the service manual information for the Canon-imageRUNNER-2230 E743 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon-imageRUNNER-2230 E743 0000 Error Code
E743 0000
Description :
There is an error in the DDI communication.
Causes :
An SCI error has occurred. The received data is faulty. A reception timeout condition has occurred. An SEQ timeout error has occurred.
Solutions :
Disconnect and then connect the flexible cable used to connect the reader unit and the printer unit.
Replace the following as necessary: flexible cable, reader controller PCB, main controller PCB.
If you are looking at this piece of content and have experience with this fault and would wish to make a contribution please be sure to leave a comment down below. Or, if you have read this article and have more questions then ask. If I have information about the issue then I will respond.
Always remember, not every error is totally the same. What treats the situation one occasion might not eliminate it the next time. While the advice in this page is obtained from the service manual and most likely should get your equipment operating, now and again additional circumstances could possibly be in play.
