Canon-imageRUNNER-2230 E002 0000 Error Code

 

Canon-imageRUNNER-2230 E002 0000 Error Code Instructions

Below you will find the service manual information for the Canon-imageRUNNER-2230 E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon-imageRUNNER-2230 E002 0000 Error Code

Service Manual Instructions for the Canon-imageRUNNER-2230 E002 0000 Error Code

E002 0000
Description :
The rise in temperature of the fixing assembly is faulty.

Causes :
While startup control is under way, the reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
While startup control is under way, the reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.



Solutions :
Reset the condition in service mode: COPIER>FUNCTION>CLEAR>ERR.
Replace the main thermistor.
Replace the DC controller PCB.


Canon FM3-1278-000 Fuser (Fixing) Unit – 120 Volt (Genuine) – $549.95

Canon imageRUNNER 2230 Fuser Removal and Replacement FM3-1278-000, FM2-0356-000


Canon imageRUNNER 2230 E000, E001, E002, E003, Error Code Reset

If you are looking at this article and have expertise in this error message and want to contribute please leave a comment below. Or, if you have read this article and have further questions then ask. If I have information about the problem then I will respond.

Always remember, not every error is absolutely identical. What fixes the complication one time may not get rid of it the next time. While the advice in this page is taken from the service manual and most often ought to get your device functioning, from time to time other causes could possibly be in play.

We will be happy to hear your thoughts

Leave a reply

Shopping cart