Lanier LD520C Magenta Drum Replacement D0392030, D0392020

 

Lanier LD520C Magenta Drum Replacement

Lanier LD520C Magenta Drum Replacement – What follows are the guidelines for the drum and developer restoration. Typically when you start discovering color streaks or color back grounding it’s a indicator that the charge grid and cleaning blade are beginning to go bad. Several providers offer you PM kits to repair the drum units though with the cost of these appearing considerably inexpensive, I’d incline towards actually changing the entire unit simply because it normally requires low technical skill-set unlike rejuvenating it which can commonly get advanced and dirty.

$119.00
in stock
as of May 9, 2019 3:22 pm
Amazon.com

Lanier LD520C Magenta D039-2040 Drum Assembly / PCU (Genuine) – $136.95
D039-2040, D039-2030, D0392030, D039-2020, D0392020

Lanier LD520C Magenta Drum Replacement and Developer Unit

The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
Lanier LD520C Magenta Drum Replacement
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.

RC Aficio MP C2030 Drum Rebuild Instructions

Instructions for rebuilding of drum unit for Ricoh Aficio MP C2030 / C2050 / C2051 / C2530 / C2550 / C2551 applications.

We will be happy to hear your thoughts

Leave a reply

Shopping cart