Lanier LD435C Black Drum Replacement B2232042, B2242042, B2232244
Lanier LD435C Black Drum Replacement – Below is the instructions for the drum and developer replacement. Usually once you start experiencing color blotches or color back grounding it can be a hint that the charge grid and cleaning blade are beginning to go bad. Several businesses offer you PM kits to renew the drum units although with the expense of these appearing reasonably low cost, I’d aim in the direction of simply swapping the complete unit given that it requires very little technical skills compared to fixing it which can often get tricky and dirty.
B2232042, B224-2042, B223-2042, B223-2244, B2242042, B2232244
Lanier LD435C Black Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
OEM B224-2042 BLACK DRUM UNIT B2232042
$129.00
in stock
Item condition: New
Ended: May 3, 06:07PST
Free shipping
eBay
as of April 15, 2024 7:27 pm
