Kyocera KM-3040 C6020 Error Code Maintenance Information
The Kyocera KM-3040 C6020 Error Code takes place when the fuser reports a increased temperature reading. Loads of things may cause this issue. So in this content you will get some servicing tips for this fault along with links to acquire a new fuser and also at the lower part of the piece of writing you’ll find a url to the illustrated fusing unit replacement directions.
Note : Fuser Related Error Codes can cause the machine not to work until the code is reset in Maintenance Mode. Below is a link to the instructions on how to reset the code through the maintenance menu.
Kyocera KM-3040 Fuser Error Reset Procedure – 302K593060
Service Handbook Recommendations for the Kyocera KM-3040 C6020 Error Code
Abnormally increased fuser thermistor center temperature
fuser unit thermistor 2 is detected 230°C/ 446°F or over for 40 milliseconds.
1. Installation defectiveness on fuser thermistor Two.
Verify the mounting condition of the fusing unit thermistor 2. If any issue is determined, correct it.
2. Malfunctioning fuser thermistor Two.
Switch out the fuser thermistor Two.
3. Damaged engine PWB.
Remove and replace the engine PWB and study for ideal function.
These particular fusing unit are fairly affordable. Like many components with the Kyocera equipment, quite a lot of times its less costly to just switch out the whole part or maintenance kit. Consequently, if you really are having difficulties because of the fuser unit, I would probably just highly recommend saving a bit of time and cash and get a whole replacement fuser. Listed below, you will find a hyperlink to the replacement instructions and also a link to buy in your complete replacement fusing assembly.
Kyocera KM-3040 Fuser Replacement Procedure
Kyocera code c6000
Kyocera code c6020 Kyocera code c6050 code Kyocera KM1620 Kyocera KM1635 Kyocera KM1650 Kyocera KM2020 Kyocera KM2030 Kyocera KM2035 Kyocera KM2050 Kyocera KM2530 Kyocera KM2540 Kyocera...