CopyStar CS-2560 C6000 Error Code Maintenance Information
I maintain a number of these out in this area and I don’t believe I’ve actually experienced the CopyStar CS-2560 C6000 Error code on one of these types of products. Having said that, these models are getting outdated and of course if you’ve had the exact same fuser assembly in it since you have had it, you could very well be seeing these types of errors. Below you can learn the service handbook advice for this error and additionally a url to get a new fuser assembly and in addition at the end of the information, a web page link to the fusing unit replacement information
Copystar CS2560 Fuser Unit – 120 Volt (Genuine) – $169.95
from: Precision Roller
Message : fusing unit Corresponding Error Codes could cause the piece of equipment not to work before the code is reset in Maintenance Mode. Below is the guidance on how to reset the code in the maintenance menu.
CopyStar CS-2560 Fuser Error Reset Procedure – 302K593060
Service Information Advice for the CopyStar CS-2560 C6000 Error Code
fuser unit heater break fusing assembly thermistor 1 found a lesser amount than 40°C/104°F for 10 s for the period of warm-up and ready in.
1. Bad fuser assembly heater M or S.
Swap out the fusing assembly heater M or S.
2. Unit installation defectiveness on fuser unit thermistor 1.
Look into the mounting state of the fuser thermistor 1. If any concern is identified, repair it.
3. Fixing thermostat activated.
Examine continuity. If none, replace the fixing thermostat.
4. Malfunctioning PWB.
Replace the power source PWB or engine PWB and evaluate for suitable operation.
5. Defective fixing heater M or S wire.
Pay attention to continuity. If none, change out the heater lamp.
Seriously, Ordering these parts one-by-one is often difficult to find or otherwise worth replacing. If your experiencing troubles while using fuser unit and you decide it’s time for you to start changing parts then its probably just the perfect time to replace the entire fusing unit because of the value. Listed below you will see a url to buy in a replacement fuser and a website link to the illustrated fuser assembly replacement instructional materials.
CopyStar CS-2560 Fuser Replacement Procedure
Copystar CS2560 Fuser Unit – 120 Volt (Genuine) – $169.95 Genuine 302K593060 Fuser Unit – 120 Volt for Copystar CS2560; Fuser Assembly / Unit – Genuine Kyocera Fuser Assembly; Copystar 302K593060 / 302H093030 / 2H093030 |
