Copystar CS-2020 C6000 Error Code Repair service Recommendations
I encounter a number of these out in this area and I do not think I’ve previously seen the Copystar CS-2020 C6000 Error code on one of these pieces of equipment. On the other hand, these pieces of equipment are getting outdated and whenever you have had the same fuser within since you have had it, you could very well be seeing an example of these errors. Below you can discover the service manual assistance for this particular error in addition to a weblink to get a fresh fuser unit as well as at the conclusion of this post, a hyperlink to the fuser assembly replacement advice
Copystar CS2020 Fuser Unit – 110 / 120 Volt (Genuine) – $139.95
from: Precision Roller
Service Manual Advice for the Copystar CS-2020 C6000 Error CodeÂ
C6000 Broken fixing heater wire In fixing warm-up, the time to reach 50°C/122°F exceeds 13.5 s, the time to reach 100°C/212°F exceeds 10 s, the time to reach the primary stabilization exceeds 10 s or the time to reach the secondary stabilization exceeds 24 s.
1. Poor contact in the thermistor connector terminals.
Reinsert the connector. Also check for continuity within the connector cable. If none, remedy or replace the cable.
2. Fixing thermistor installed incorrectly.
Check and reinstall if necessary.
3. Fixing thermostat triggered.
Check for continuity. If none, replace the fixing thermostat.
4. Fixing heater M or S installed incorrectly.
Check and reinstall if necessary.
5. Broken fixing heater M or S wire.
Check for continuity. If none, replace the heater lamp.
Genuinely, Ordering these parts specifically is either difficult to get or otherwise worth changing. If your getting difficulties considering the fusing unit and you decide it’s time to start replacing components then its quite likely just the perfect time to remove and replace the whole fusing unit due to the value. Beneath you will discover a link to order in a replacement fuser unit and a hyperlink to the illustrated fusing unit replacement details.
Copystar CS-2020 Fuser Replacement Procedure – – FK-410, 302C993059
Copystar CS2020 Fuser Unit – 110 / 120 Volt (Genuine) – $139.95 Genuine 302C993059 Fuser Unit – 110 / 120 Volt for Copystar CS2020; Fuser Assembly / Unit – Genuine Kyocera Mita Fuser Assembly – Estimated Yield 300,000 pages; Copystar 302C993059 / 302C993058 / 302C993057 / 302C993056 / 2C993055 / 2C993053 / 2C993052 / 2C993051 / 2C993050 |
