Lanier LD127 SC320 Error Code Maintenance Helpful tips
Huge majority of the time if you see the Lanier LD127 SC320 Error Code the polygon motor is many times locked up and it possesses to much friction in regards to the motor bushing and polygon mirror pole. Down below you’ll find what the instruction manual has to say on this subject and a small amount of assistance of my own. Furthermore, you will locate web links to buy a new polygon motor and a link to the replacement instructions right after the written content.
Service Manual Advice for the Lanier LD127 SC320 Error Code : Polygon motor error
-Definition- [B]
The polygon motor does not reach its operating speed within 10 seconds after
the polygon motor on signal, or the lock signal is not detected for more than 200
ms continuously during operation.
– Possible causes –
• Polygon mirror motor defective
• Poor connection between the polygon mirror motor driver and the BICU board
• BICU board defective
Note : The laser beam bounces off the polygon mirrors which is why they should never be handled apart from if absolutely required. Moreover, if you do get them grimey or notice they are dirty, they are EXTREMELY hypersensitive and can scratch with the smallest speck of foreign matter. Employ the softest, cleanest cloth you can come across to clean them off and don’t implement virtually no pressure.
I personally deal with these all approximately the same way. I primary replicate the problem and listen to see whether I can notice the motor start up. If it’s not necessarily locked up, they have a tendency to sound like a really obnoxious cooling fan. You can identify it the way you want, however it’s not usually difficult to overlook. Second of all, I take the motor out, remove the polygon mirror from the motor bushing, take a alcohol slightly wet que tip and clean up the interior of the motor bushing, clean off the post on the polygon mirror with alcohol, then lubricate the two pieces with a tiny bit of thin oil. Lately, I have been using 3 n 0ne oil. I put it back together again and spin it a little bit to confirm that its free then put the machine back together again and try it out again.
- Now if it is still locked up before you put it back in the machine, then try the process over.
- If you still hear the sound then you can try the process again or order in a replacement motor.
- You can always, just order in the replacement motor if you don’t want to try this procedure.
- And if I do this operation and I get a call back in a few weeks or months then I just replace the motor.
In the imagine shown below you’ll encounter a picture of a similar motor. I’ve circled the component the holds the polygon mirror down. The black piece will turn so you can take out the polygon mirror assembly away from the motor bushing. Ensure that you switch the black component back into placement when you finally reinstall the polygon mirror assembly, and just as before, make certain you do not touch the mirrors. Grab it around the bottom part.
Click on the link below for removal and replacement instructions
Lanier LD127 Laser Motor Replacement Procedure
There are other factors that can this error, but 99% of the time this will take care of your problem.Â
