Savin 2522 SC320 Error Code Repair service Tips
Great deal of the time once you see the Savin 2522 SC320 Error Code the polygon motor is frequently locked up and possesses to much friction involving the motor bushing and polygon mirror shaft. Down the page you will learn what the instruction manual says on this subject and a little bit of solutions of my own. Aside from that, you will view urls to buy a complete replacement polygon motor and a link to the replacement instructions following the article.
Ricoh AX06-0181 Polygon Mirror Motor (Genuine) – $129.95
from: Precision Roller
Service Manual Advice for the Savin 2522 SC320 Error Code : Polygon motor error
-Definition- [B]
The polygon motor does not reach its operating speed within 10 seconds after
the polygon motor on signal, or the lock signal is not detected for more than 200
ms continuously during operation.
– Possible causes –
• Polygon mirror motor defective
• Poor connection between the polygon mirror motor driver and the BICU board
• BICU board defective
Note : The laser beam bounces off the polygon mirrors which means they should never be contacted except if absolutely essential. Moreover, if one does get them filthy or notice they are dirty, they are Considerably delicate and can damage with the smallest speck of particles. Try the softest, cleanest soft towel you can acquire to clean them off and do not apply little force.
I personally handle these all approximately the exact same way. I first of all duplicate the scenario and listen to verify that I can notice the motor turn on. If it’s not actually locked up, they have a tendency to sound like a really obnoxious cooling fan. You can summarize it how you want, however it’s not typically difficult to ignore. Additionally, I take the motor out, remove the polygon mirror from the motor bushing, take a alcohol slightly wet que tip and cleanse the inside of the motor bushing, clean off the post on the polygon mirror with alcohol, then lube the two locations with a tiny bit of thin oil. Lately, I have been using 3 n 0ne oil. I put it together again and spin it slightly to confirm that its free then put the machine back together and check again.
- Now if it is still locked up before you put it back in the machine, then try the process over.
- If you still hear the sound then you can try the process again or order in a replacement motor.
- You can always, just order in the replacement motor if you don’t want to try this procedure.
- And if I do this operation and I get a call back in a few weeks or months then I just replace the motor.
In the imagine underneath you will look at a picture of a very similar motor. I’ve circled the item the holds the polygon mirror down. The black piece will swivel so you can remove the polygon mirror assembly out of the motor bushing. Ensure that you spin the black section back into positioning whenever you reinstall the polygon mirror assembly, and just as before, ensure that you do not touch the mirrors. Grip it nearby the base.
Click on the link below for removal and replacement instructions
Savin 2522 Laser Motor Replacement Procedure
There are other factors that can this error, but 99% of the time this will take care of your problem.Â
Ricoh AX06-0181 Polygon Mirror Motor (Genuine) – $129.95 Genuine Ricoh AX06-0181 Polygon Mirror Motor; Motor – Genuine Ricoh Part; Mfr PNs: Ricoh AX05-0141, AX060181, AX050141, Savin AX06-0181, AX05-0141, AX060181, AX050141, Gestetner AX06-0181, AX05-0141, AX060181, AX050141, Lanier AX06-0181, AX05-0141, AX060181, AX050141 |
