Brother HL-L5000D Fuser Replacement Procedure D005WR001

 

Brother HL-L5000D Fuser Replacement Procedure

Below are the illustrated Brother HL-L5000D Fuser Replacement Instructions along with links to order in your replacement fuser.
NEW GENUINE BROTHER FUSER MFC-L5900DW HL-L5000D HL-L5100DN HL-L5200DW D005WR001

Last updated on March 24, 2024 10:50 am

Brother HL-L5000D Back cover / Outer chute
(1) Open the back cover.
(2) Push both ribs of the back cover in the direction of the arrows, and remove the two bosses on the outer chute.
(3) Remove the back cover from the boss A, and remove the back cover.
(4) Open the outer chute approximately 80 degrees. Remove the outer chute from the boss B, and remove the outer chute from the machine.
Note:
• Be careful not to damage the ribs inside the back cover.

Brother HL-L5000D Fuser cover
(1) Push the two knobs on the fuser cover, and pull the fuser cover down in the direction of the arrow.
(2) Remove the fuser cover from the bosses on the fuser unit, and remove the fuser cover

Brother HL-L5000D Fuser Replacement

Some parts inside the machine are extremely hot immediately after the machine is used.
When opening the front cover ASSY or back cover to access any parts inside the machine, never touch the shaded parts shown in the following figures.
Note:
• Do not touch the fuser unit film directly. It may cause the fuser unit failure.
(1) Remove the taptite bind B M4x12 screw, and remove the fuser unit line cover R.
(2) Open the front cover, and release the nip of the pressure roller.
(3) Slide the lower rear nip release link in the direction of the arrow 3b while pulling it in the direction of the arrow 3a to remove the rear nip release link.
(4) Remove the taptite pan B M4x14 screw. Release the hook, and remove the fuser unit line cover L.
(5) Release the heater harness of the fuser unit from the securing fixtures, and disconnect it from the low-voltage heater harness.
(6) Disconnect the center thermistor harness and the side thermistor harness from the eject sensor PCB ASSY.

Assembling Note:
• After connecting the heater harness, pull the connector on the heater harness side while holding the connector on the low-voltage heater harness side to make sure it is locked.
Note:
• When disconnecting the harness, hold the top of the PCB connector to prevent the PCB connector being damaged.
(7) Close the front cover and return the pressure roller nip.
(8) Remove the taptite pan B M4x14 screw, and remove the fuser unit.
Note:
• Make sure that the front cover is closed when removing the fuser unit.

Brother HL-L5000D Fuser Replacement

Time will tell if these machines have the same issues as the last model. I did work on one the other day and while the fuser looks similar to the last model, they are different. Click on the link below to order in your replacement fuser.
NEW GENUINE BROTHER FUSER MFC-L5900DW HL-L5000D HL-L5100DN HL-L5200DW D005WR001

We will be happy to hear your thoughts

Leave a reply

Shopping cart