Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002

 

Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002 Instructions

Below you will find the service manual information for the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002 along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002

Service Manual Instructions for the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002

E531 8002 Staple Motor (M9) error

Description :
Description At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.

Causes :
Staple Motor (M9) error

Solutions :
Remedy

1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).

2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).

3. Replace the Rear Alignment Plate HP Sensor (S5).

4. Replace the Rear Alignment Motor (M5).

5. Replace the Finisher Controller PCB.

Remember, not every error is exactly the same. What fixes the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8002 one time might not solve it the next time. While the information above comes from the service manual and generally should get your machine up and running, sometimes other factors might be in play.

If you are reading this article and have experience with this error and would like to contribute please leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the issue then I will respond.

We will be happy to hear your thoughts

Leave a reply

Shopping cart