Kyocera FS3040MFP and FS3140MFP C6000 Error Code
Below, you will find what the service manual has to say on the Kyocera FS3040MFP and FS3140MFP C6000 Error Code along with some additional troubleshooting tips and at the bottom of the article you will find a link to the fuser replacement instructions and links to order in a new fuser if needed.
Service Manual Tips for the Kyocera FS3040MFP and FS3140MFP C6000 Error Code
Description
6000 Broken fuser heater wire
The temperature does not reach 100°C/212°F after the fuser heater has been turned on continuously for 30 s.
The temperature does not rise by 1°C/1.8°F after the fuser heater lamp has been turned on continuously for 15 s during warm-up or at standby.(Only when the detection temperature is less than 200°C.)
Causes :
Defective connector cable or poor contact in the connector.
Fuser heater and power source PWB (YC102)
Fuser unit and engine PWB (YC506)
Deformed connector pin.
Defective triac.
Fuser thermostat triggered.
Broken fuser heater wire.
Solutions :
Reinsert the connector. Also check for continuity within the connector cable. If none, remedy or replace the cable.
Reinsert the fuser unit
Replace the fuser unit
Click on the link below for the fuser replacement instructions
Kyocera FS3040MFP, FS3140MFP, FS3540MFP Fuser Replacement