HP LaserJet Enterprise M680 and M651 Fuser Replacement

 

HP LaserJet Enterprise M680 and M651 Fuser Replacement Procedure

Below you will find the illustrated instructions for the HP LaserJet Enterprise M680 and M651 Fuser Replacement along with fuser buying options. These fusers are rated at around 150,000 prints and / or copies. The machine will give you a supply low warning message the will later lead to a replace supply message and on most machines will require replacement of the part before the machine will work again. Just about anybody can replace these new fusers. Follow the instructions below and you will be good to go.
HP LaserJet Enterprise M680 / M651 CE246A – HP Fuser Kit

Instructions for the HP LaserJet Enterprise M680 and M651 Fuser Replacement

CAUTION: The fuser might be hot. Allow enough time after turning off the product power for the fuser to cool.
NOTE: The product detects a new fuser using a fusible link that blows after 100 pages have been printed. If a new fuser is installed for troubleshooting purposes, be sure to remove it before printing 100 pages.
1. Open the right-door assembly.

HP LaserJet Enterprise M680 and M651 right side door access

2. Grasp the handles and squeeze the blue release levers.
Pull the fuser straight out of the product to remove it.

HP LaserJet Enterprise M680 and M651 Fuser Replacement

That’s it. Your all done. Close the covers back up. Turn the machine on and start printing. As long as the fuser is new the message should go away till the next 150,000 life cycle.

We will be happy to hear your thoughts

Leave a reply

Shopping cart