Canon imageRUNNER 1750,1740,1730 Service Mode / Fuser Code Reset

 

Canon imageRUNNER 1750,1740,1730 Service Mode / Fuser Code Reset

When these machines run into fuser problems the machine stops working, it throws you a message you don’t understand and your either looking on the internet or calling in a repair tech to find out whats going on. In this article you will find out how to get into the Canon imageRUNNER 1750,1740,1730 Service Mode and how to reset the fuser code.

Canon imageRUNNER 1750,1740,1730 Service Mode

The fuser code can either be a serious problem or a minor repair. In most cases you reset the code and see if it happens again. At that point, you either replace the fuser or call in a repair tech, who will probably tell you they need to replace the fuser. Check out the end of the article to a link to the illustrated fuser replacement instructions which is easy and can be handled by just about anybody.

Fuser Error Codes :
E000
E001
E002
E003
E004

Canon imageRUNNER 1750,1740,1730 Service Mode
Push [Additional Functions] Key > push 2, 8 Key > push [Additional Functions] Key.

  1. Scroll down to #Clear and enter
  2. Scroll down to Engine and enter
  3. Scroll down to ERRCLR and enter
  4. Turn the machine off then back on.

That should correct the issue if it was just a minor error. However, if it goes through the warm up and the error comes back or if it comes back in the next week or month then you most likely have a more serious problem. Below you will find a link to the replacement instructions and also you will find a link to order in a new fuser if needed.

Canon imageRUNNER 1730 Fuser Unit Removal and Replacement Procedure

How to change the Fixing Assembly for the imageRUNNER ADVANCE 400IF.

How to change the Fixing Assembly for the imageRUNNER ADVANCE 400IF. Canon imageRUNNER ADVANCE 400IF Fixing Assembly, compatible with: For ...

We will be happy to hear your thoughts

Leave a reply

Shopping cart