Brother HL – 3040CN / 3070CW Replace Fuser Message and Reset
Instructions for the Brother HL – 3040CN / 3070CW Replace Fuser Message and Reset Procedure
When these machines reach 50,000 prints the display will start to read Replace Fuser. The good news is that the machine will continue to work. The bad news is that one of your consumables has reached the recommended life limit of the part. In most cases the fuser is still holding up pretty good but is starting to show signs of extreme usage. Typically, the lower pressure roller is starting to get warped and the pick fingers on the hot roller are starting to score the outer coating of the roller.
Below you will find a link to order in a replacement fusing assembly. Also, you will find a link to the illustrated removal and replacement instructions. Finally at the bottom of this article you will find the Fuser Life Reset Procedure to clear the replace fuser message of your machines display and to start over on your next 50,000 pages.
Click on the link below for the removal and replacement procedure
—  Brother Color HL- 3040CN / 3070CW Fuser Replacement  — Â
________________________________________________________________________
Brother HL – 3040CN / 3070CW Fuser Life Reset Procedure
1. Press the Go button and UP Arrow Button at the same time.
2. If done correctly then the machine will show  “Drum Unit” on the display and you are in the Parts Life Reset Menu. (It might take a few tries in order to get into the reset menu.)
3. Use the UP or DOWN Arrow buttons to scroll until “Fuser Unit” is shown on the display. Then Press the OK button.
4. The machine will ask you to verify your choice by pressing the OK button again. Press the button and the machine will reset the counter and return to a ready state.
This was very helpful ! Now the printer works , but makes a click , click sound till it finishes printing ? What do you suppose that is ?
Thanks, Neal