Kyocera FS1035MFP – FS1135MFP Error Code C6030 Problems

 

Diagnostic Aids for the Kyocera FS1035MFP – FS1135MFP Error Code C6030 Problems

The  Kyocera FS1035MFP – FS1135MFP Error Code C6030 is more of an electrical problem so troubleshooting this fuser error might be a little more difficult than others. If you are uncomfortable with dealing with electrical issues then you might just want to move on to the fuser replacement section and get yourself a replacement fusing assembly. If you feel like doing some troubleshooting then below you can find a replacement fusing assembly  and at the end of the article you can find instructions for the fusing assembly  replacement.

out of stock
as of March 25, 2024 12:52 am
Amazon.com
Last updated on March 25, 2024 12:52 am

FK-170 (U) Fuser Kit FS1035MFP - FS1135MFP -100K

Kyocera FS1035MFP – FS1135MFP Error Code C6030 Description
Broken fuser thermistor wire
Input from fuser thermistor is 0 (A/D value).

Kyocera FS1035MFP - FS1135MFP Error Code C6030 Problems

Service Manual Diagnostic Aids for Error Code C6030
Poor contact in the fuser thermistor connector terminals.
Reinsert the connector
Broken fuser thermistor wire.
Fuser thermistor installed incorrectly.
Fuser thermal cutout triggered.
Fuser heater installed incorrectly.
Broken Fuser heater wire.
Replace the fuser unit

Additional Diagnostic Aids

1. Turn the machine off then back on. You might want to turn the machine off, unplug it, wait 30 to 60 seconds, then plug back in. Sudden losses of power like lightening storms, windy days, or if power lines are being worked on nearby, can cause accidental fuser errors as the machine can be confused and read temperature readings at the wrong time.

2. Remove the side covers or the open the rear door and turn the machine on. If it comes up to a ready state then print off a report. Look for the lamp in the fusing assembly to come on.

3. If the lamp comes on then I would remove the fusing assembly and clean the thermistor off of any debris. If debris gets on the thermistor then it can report back incorrect temperature reading to the machine. This can lead to fuser errors in the machine.

4. If the lamp doesn’t turn on then you will want to take the fusing assembly out and check continuity across the lamp, across the wires, and across the thermal fuse. If if fails then replace the fusing unit.

5. Replace the fusing assembly.

Click on the link to find the illustrated removal and replacement instructions for the fuser

Kyocera FS1035MFP  FS1135MFP Fuser Replacement  FK-170U


out of stock
as of March 25, 2024 12:52 am
Amazon.com
Last updated on March 25, 2024 12:52 am

We will be happy to hear your thoughts

Leave a reply

Shopping cart