Repair Tips and Advice for the 010-351 Replace Fuser Message on Phaser 6140 Machines
The fusing assemblies are rated at roughly 50,000 prints. Due to how the fusing assemblies are built and the speeds they print at, the fusers typically are pretty worn out at this point if not already showing early signs of print quality issues. When you receive the  010-351 Replace Fuser Message I strongly recommend replacing the part at this point rather than just resetting the life counter. Most manufactures have done a pretty good job and figuring out the life of these units. Failure to replace the parts at this time could lead to print quality issues and unwanted down to to your office equipment.
Checking the life of your Fusing Assembly – In order to find out the life of your fusing assembly you will need to log on to the CWIS to find the status of the life counter. The CWIS is an embedded web page that can be accessed through your internet browser. Find the IP address of your printer and insert in the browser window and enter. The browser should open up a web page that shows the status of your machine and the life of the consumables.
–
–
Phaser Xerox 6140 Fusing Assembly – 675K86295
Troubleshooting Tips for the 010-351 Replace Fuser Message
1. Replace the Fusing Assembly and reset the Fuser Life Counter
Fuser Replacement and Life Reset – Xerox Phaser 6140 Color Printer
2. Check the connections from the fusing assembly to the MCU
3. If replacing and resetting the fusing assembly life counter does not solve the problem replace the MCU board.
Click on the link below for additional information and buying options
Phaser Xerox 6140 Fusing Assembly –
