Diagnostic Aids – Fuser Error Message – Brother HL – 4140, 4150, 4570

 

Repair Advice on the Brother HL – 4140, 4150, and 4570 Fuser Error Message

The fuser error message is a pretty generic error on these machines. If you were to put it into service mode you probably could get a more specific message. There are several things you can try to resolve this error before attempting to replace the fusing assembly. In this article I’ll try to walk you through a few simple repair steps and provide you with information on how to reset the fuser error code manually and provide instructions on how to replace the fusing assembly and reset the life counter if needed.

Fuser Error Message Brother HL - 4140, 4150, 4570



Last updated on February 15, 2024 9:20 am

Troubleshooting Tips for the Fuser Error Message

1. Turn the power off then back on. Turn off, unplug power and communication cables, wait 15 to 30 minutes, and try again.

2. Check power source. I’ve seen improper voltage from the wall socket cause this problem. Also, make sure the printer is not plugged into a power strip with multiple devices and not on a battery back up.

3. Click on the link below to try to manually reset the fuser error code. 95% of the time this step will fix the problem

Fuser Error Code Reset – Brother HL – 4140, 4150, 4570 Series

4. Remove and re-install the fusing assembly.

5. Replace the fusing assembly. If you replace the fusing assembly don’t forget to reset the fuser life counter.

Click on the Link below for Fuser Removal on these machines

Brother HL 4140, 4150, 4570 Fuser Assembly Removal and Reset Procedure

Click on the Link below for buying options and additional details on the  LY0748001 Fusing Assembly


Last updated on February 15, 2024 9:20 am

We will be happy to hear your thoughts

Leave a reply

Shopping cart