Replace Fuser Message and Reset – Brother DCP / MFC 9010, 9120, 9320
Brother DCP / MFC 9010, 9120, 9320 – Replace Fuser Message and Reset
The Replace Fuser message on these machines comes up after around 50,000 prints and copies. Like most Brother machines this particular fuser error doesn’t cause the machine to quit working. At this time I strongly recommend that you remove the fusing assembly and check for the common signs of wear and tear. On most fusing units, about this time, the pick fingers are starting to wear down the surface of the hot roller. The sides or middle of the hot roller might be showing signs of wear or toner build up. Also, you will want to check the lower pressure roller for signs of wear like wrinkles or the outer coating coming apart. I’ve provided the fusing unit removal instructions in another article. Click on the link below the reset instructions for the information.
Fuser Counter Reset Procedure
1. Press the 3 and 9 buttons at the same time in the ready state.
The Reset Menu/Drum will appear on the display.
2. Scroll through the menu to select Fuser.
3. Press the OK button.
The display will read 1. Reset 2. Exit on the display.
4. Press the 1 button when resetting the life counter of the fuser unit. Press the 2 button if not resetting.
5. The Fuser/Accepted message will appear on the display if the 1 button is pressed. The page counter of the fuser unit is reset, and the number of replacement times is increased by one. Then, the machine returns to the ready state. If pressing the 2 button, the machine do not reset the page counter and the Fuser will appear on the display.
Click on the link below for Fuser Replacement instructions.
Brother DCP/MFC 9010, 9120, 9320 Fuser Unit Removal Procedure
Click on the link below for additional buying options and information.
