Replace Fuser Message – Xerox Phaser 6300, 6350, and 6360 Printer

 

Replace Fuser Message for the Xerox Phaser 6300, 6350, and 6360 Printer


The replace fuser  message is a result of the fusing assembly life counter reaching approximately 100,000 prints. I’ve seen a lot of these fusers  and majority of the ones that I’ve seen the fusing units at this point show several signs of extreme wear like warped or wrinkled pressure rollers, discolored or peeling hot rollers, and occasional  flat spots in the pressure roller. Back in the day you use to be able to reset the counters and if the part looked good enough you could keep printing. The counter in this machine is recorded by a chip so either the fuser  or chip needs to be replaced. Also, the fusers  now a day aren’t made like they use to and with the extreme speeds at which they print, they tend to wear out more often. I found that on Dell and Xerox machines that once you get this message it’s just  best to replace the fusing unit rather than trying to come up with a solution to work around the replace fuser  message. Sooner rather than later the fuser is going to fall apart and your machine will be down.
Xerox Phaser 6300, 6350, and 6360 FUSER – 115R00035

Xerox Phaser 6300, 6350, and 6360 Replace Fuser Message photo

Service Manual Tips for Troubleshooting the Replace Fuser Message
Code 207: Replace Fuser
Print the Supplies Usage page to verify remaining life and Fuser install date.
1 Check the Fuser connector for damage. Re-establish proper connection or replace the parts concerned.
2 Replace the Fuser.
3 Replace the EEPROM Board
4 Check all pins on the EEPROM Harness PL10.1.8 for continuity.
1. Disconnect P/J191  and P/J144.
2. Check continuity between J191<=>J144.
No – Replace the EEPROM Harness.
5 Check all pins on the FSR/ADC Harness PL5.2.28 for continuity.
1. Disconnect P/J36  and J361.
2. Check continuity between J36  <=> J361.
Yes – Replace the Engine Control Board
No – Replace the FSR/ADC Harness.

Xerox Phaser 6300 Fuser Removal

 

For further details and pricing options click on the link below for more information.
Xerox Phaser 6300, 6350, and 6360 FUSER  – 115R00035


1 Comment

Leave a reply

Shopping cart