Nov 122017
 
 

Savin 8025ESPF AE042029, AE020161 AE042029, AE020161 Lower Pressure Roller / Cleaning Roller Replacement Instructions

Below you will find the illustrated Savin 8025ESPF AE042029, AE020161 AE042029, AE020161 Lower Pressure Roller / Cleaning Roller Replacement instuctions. Yeah, I know, these machines are getting on in age. Excuse me, I just happened to look up the instructions, saw they were pretty straight forward, and found out you can still get the parts. So, I figured what the heck.

A lot of time if you have thumping or maybe a popping or creaking noise coming out of the fuser then you might have a dirty cleaning roller or a worn out pressure roller. Below you will find the illustrated replacement instructions along with links to order in a replacement part.


RCAF1022FCR

from: Precision Roller


AE020161 – $39.95

from: Precision Roller

1. Savin 8025ESPF FUSING UNIT
CAUTION
Allow time for the unit to cool before doing the following procedure.
1. Release the duplex unit, if it has been installed, and open the right cover.
2. Remove the fusing unit [A] (2 screws).

2-3. Savin 8025ESPF Fuser Top Cover and Pick Fingers
1. Remove the fusing unit.
2. Remove the fusing upper cover [A] (4 screws).
3. Remove the pressure springs [B].
4. Remove the hot roller stripper bracket [C] (3 screws).

4. Savin 8025ESPF HOT ROLLER AND FUSING LAMP
1. Remove the fusing unit.
2. Remove the fusing upper cover.
3. Remove the pressure springs.
4. Remove the hot roller stripper bracket.
5. Remove the fusing lamps (4 screws) and hot roller assembly [A].
NOTE: Do not touch the surface of the fusing lamp with bare hands.
6. Replace the hot roller [B] (2 C-rings, 1 gear, 2 bushings).
Reinstallation Instructions at bottom of illustrated instructions
NOTE: 1) Apply grease (Barrierta) to the inner surface of the bushing.
2) Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the protective sheet on the new roller. After installation, remove the protective sheet.
3) Do not touch the surface of the rollers.
4) When reinstalling the fusing lamp, secure the front screws first.
5) Be careful not to damage the surface of the hot roller.

5.  Savin 8025ESPF PRESSURE ROLLER/CLEANING ROLLER
1. Remove the fusing lamp and hot roller assembly.
2. Replace the pressure roller [A] (1 E-ring, 2 bushings, 1 spring).
3. Replace the cleaning roller [B].
NOTE: 1) Apply grease (Barrierta) to the inner surface of the bushing for the pressure roller.
2) Do not touch the surface of the rollers.