Lanier LD620C Magenta Drum Replacement
Lanier LD620C Magenta Drum Replacement – Below are the directions for the drum and developer replacement. Usually when you begin noticing color blotches or color back grounding it can be a indicator that the charge grid and cleaning blade are starting to go bad. Certain providers offer you PM kits to reconstruct the drum units though with the cost of these currently being moderately low cost, I’d personally aim in the direction of merely changing the total unit considering it will take low technical ability when compared to recovering it which can often become advanced and dirty.
Lanier LD620C Magenta D039-2040 Drum Assembly / PCU (Genuine) – $136.95
D039-2040, D039-2030, D0392030, D039-2020, D0392020
Lanier LD620C Magenta Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
RC Aficio MP C2030 Drum Rebuild Instructions
Instructions for rebuilding of drum unit for Ricoh Aficio MP C2030 / C2050 / C2051 / C2530 / C2550 / C2551 applications.
