Lanier LD520C Cyan Drum Replacement
Lanier LD520C Cyan Drum Replacement – In this article are the guidelines for the drum and developer replacement. Generally when you begin coming across color blotches or color back grounding it can be a warning that the charge grid and cleaning blade are starting to go bad. Certain providers will sell PM solutions and products to rebuild the drum units although with the price of these being moderately cheap, I’d lean in the direction of merely changing the total unit considering it demands limited technical experience as opposed to rejuvenating it which can become complicated and dirty.
Lanier LD520C Cyan D039-2040 Drum Assembly / PCU (Genuine) – $136.95
D039-2040, D039-2030, D0392030, D039-2020, D0392020
Lanier LD520C Cyan Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
RC Aficio MP C2030 Drum Rebuild Instructions
Instructions for rebuilding of drum unit for Ricoh Aficio MP C2030 / C2050 / C2051 / C2530 / C2550 / C2551 applications.
