Savin C9025 Black Drum Replacement
Savin C9025 Black Drum Replacement – Just below is the details for the drum and developer repair. Commonly once you begin finding color streaks or color back grounding it is a clue that the charge grid and cleaning blade are beginning to go bad. A handful of businesses advertise PM kits to restructure the drum units although with the value of these appearing considerably inexpensive, I’d personally lean towards actually exchanging the total unit since it usually requires very little technical capability when compared to restoring it which often can become complicated and dirty.
Savin C9025 Black D039-2040 Drum Assembly / PCU (Genuine) – $136.95
D039-2040, D039-2030, D0392030, D039-2020, D0392020
Savin C9025 Black Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
Ricoh D039-2040 Drum Assembly / PCU (Genuine) – $136.95Genuine Ricoh D039-2040 Drum Assembly / PCU; Drum Unit – Genuine Ricoh Brand – Sold Each, uses One for Each Color – Estimated Yield 80,000 pages – Made in China; Mfr PNs: Ricoh D039-2030, D0392030, D039-2020, D0392020, Savin D039-2030, D0392030, D039-2020, D0392020, Lanier D039-2030, D0392030, D039-2020, D0392020, Gestetner D039-2030, D0392030, D039-2020, D0392020 |
