Savin C9020 Magenta Drum Replacement
Savin C9020 Magenta Drum Replacement – What follows are the guidelines for the drum and developer repair. Usually when you begin viewing color blotches or color back grounding it is a sign that the charge grid and cleaning blade are starting to go bad. A couple of businesses offer up PM products and solutions to restore the drum units although with the cost of these appearing to some degree low cost, I’d personally incline towards merely swapping the total unit given it normally requires little technical capability when compared to restoring it which often can get challenging and dirty.
QFIb9)G1v9BScs)Gnm2Q~~60_1.JPG)
Savin C9020 Magenta D039-2040 Drum Assembly / PCU (Genuine) – $136.95
D039-2040, D039-2030, D0392030, D039-2020, D0392020
Savin C9020 Magenta Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
BĘBEN RICOH COLOR MPC2010 MPC2030 MPC2050 MPC2051 MPC2530 MPC2550 MPC2551
Wymiana bębna w kopiarce kolorowej Ricoh Aficio MPC-2010 MPC-2030 MPC-2050 MPC-2051 MPC-2530 MPC-2550 MPC-2551 Bęben i listwa czyszcząca w ...
