Lanier LD445C Magenta Drum Replacement B2242027, B2232027, B2232043, B2232045, B2232246
Lanier LD445C Magenta Drum Replacement B2242027, B2232027, B2232043, B2232045, B2232246
Lanier LD445C Magenta Drum Replacement – Below are the details for the drum and developer restoration. Ordinarily when you start experiencing color lines or color back grounding it’s a signal that the charge grid and cleaning blade are beginning to go bad. Certain providers advertise PM products and solutions to rebuild the drum units although with the buying price of these appearing moderately low priced, I would personally aim towards just replacing the entire unit simply because it will take minimal technical ability unlike restoring it which often can become complex and dirty.
B223-2027, B223-2043, B223-2245, B2232027, B2232043, B2232045
Lanier LD445C Magenta Drum Replacement and Developer Unit
The new drum unit has a front cover and a front joint. When you attach the new drum unit to the development unit, remove a front cover and a front joint at first.
And use them for reassembling the new drum unit and development unit.
If you install a new drum unit, set SP 3902-xxx to “1”.
Black: 3902-009
Yellow: 3902-010
Cyan: 3902-011
Magenta: 3902-012
If you do this, then the machine will reset the PM counter for the drum unit automatically, after you turn the power on again.
Turn the machine power off.
1-2. PCU ( “PCU”)
3. Front cover [A] ( x 2)
4. Do not touch the bearing [B] after removing the front cover. The bearing is properly applied with lubricant.
Note: Remove the toner duct [G] first to avoid breaking it during this procedure.
5. Remove the bushing [C] of the development roller at the rear of the PCU ( x 1).
6. Remove the front joint [D] ( x 1, x 1).
The front joint [D] is firmly set. Remove it with a watchmaker’s or jeweller’s screwdriver.
Drum unit [E] and Development Unit [F] [G]
When the development unit is removed from the drum unit, clean the entrance mylar [G] with a vacuum.
If you change the development unit, do the ACC procedure.
A. Turn the machine power off.
B. Development unit ( “Drum Unit and Development Unit”)
7. Hopper cover [A] (hook x 3)
8. Shake a bag of developer and pour it into the development hopper [B].
9. Reattach the hopper cover (hook x 3)
10. Turn the machine power on. The machine initializes the developer and resets the PM counter for the developer. (For details of the developer initialization result, see “Developer Initialization Result” in the “Troubleshooting” chapter.
8. Do the ACC procedure.
Ricoh Aficio MP C2500 Drum and Blade Kit Video Instructions
This is an instructional video on how to rebuild a Ricoh Aficio MPC2500 and MPC4500 drum and blade kit. If you have any questions on how to install this kit please feel free to contact us...
