CS-3040 C6000 Error Code Service Information
I have a few of these in the area and I do not think I’ve previously witnessed the CS-3040 C6000 Error Code on one of these products. However, these models are getting outdated and whenever you’ve had the identical fuser unit in it ever since you’ve had it, you may possibly be seeing an example of these errors. Below you will see the service manual information for this error accompanied by a link to purchase a fresh fuser as well as at the completion of this article, a hyperlink for the fuser assembly replacement steps.
Copystar CS3040 Fuser Unit – 120 Volt (Genuine) – $169.95
from: Precision Roller
Please note : fuser assembly Related Error Codes might result in the unit to fail to perform until the code is reset in Maintenance Mode. Down the page is the directions on methods to reset the code with the maintenance menu.
CopyStar CS-3040 Fuser Error Reset Procedure – 302K593060
Service Information Strategies for the CS-3040 C6000 Error Code
fuser heater stop fusing assembly thermistor 1 found a lesser amount than 40°C/104°F for 10 s during warm-up and ready in.
1. Flawed fuser assembly heater M or S.
Switch out the fuser unit heater M or S.
2. Installment defectiveness on fuser assembly thermistor 1.
Inspect the mounting state of the fuser unit thermistor 1. If any issue is uncovered, correct it.
3. Fixing thermostat triggered.
Check for continuity. If none, swap out the fixing thermostat.
4. Bad PWB.
Exchange the power source PWB or engine PWB and analyze for right operation.
5. Ruined fixing heater M or S wire.
Pay attention to continuity. If none, exchange the heater lamp.
Actually, Purchasing these parts one-by-one is either nearly impossible to find or otherwise worth replacing. If your getting worries considering the fusing assembly and you decide it’s time to start replacing items it is generally just time to change out the full fusing unit provided the cost. Beneath you will find a link to obtain in a replacement fusing unit and a website link to the illustrated fusing unit replacement directions.
CopyStar CS-3040 Fuser Replacement Procedure
Copystar CS3040 Fuser Unit – 120 Volt (Genuine) – $169.95 Genuine 302K593060 Fuser Unit – 120 Volt for Copystar CS3040; Fuser Assembly / Unit – Genuine Kyocera Fuser Assembly; Copystar 302K593060 / 302H093030 / 2H093030 |
