CopyStar CS-300i C6000 Error Code Repair service Information

 

CopyStar CS-300i C6000 Error Code Repair service Information

I encounter a a number of these in the area and I do not believe I’ve ever personally seen the CopyStar CS-300i C6000 Error code on one of these types of pieces of equipment. Nevertheless, these models are getting more aged and if you have had the same fusing assembly within since you have had it, you could be seeing an example of these errors. Below you will find the service guide help and advice for this kind of error in addition to a link to get a newer fuser assembly and at the completion of the content, a url on the fuser unit replacement guidance

CopyStar CS-300i C6000 Error Code


Copystar CS300i Fuser Unit – 120 Volt (Genuine) – $169.95

from: Precision Roller

Notice : fuser unit Connected Error Codes result in the model not to function before the code is reset in Maintenance Mode. Below is the directions on how you can reset the code by way of the maintenance menu.

CopyStar CS-300i Fuser Error Reset Procedure – 302K593060

Service Guide Useful information for the CopyStar CS-300i C6000 Error Code

fuser assembly heater stop fuser thermistor 1 detected lower than 40°C/104°F for 10 s within the warm-up and ready in.

1. Faulty fuser unit heater M or S.
Replace the fusing unit heater M or S.

2. Unit installation defectiveness on fuser unit thermistor 1.
Check out the mounting condition of the fuser thermistor 1. If any concern is spotted, correct it.

3. Fixing thermostat initiated.
Look for continuity. If none, replace the fixing thermostat.

4. Bad PWB.
Change the power source PWB or engine PWB and check for ideal operation.

5. Defective fixing heater M or S wire.
Verify continuity. If none, exchange the heater lamp.

Frankly, Getting these parts specifically is often difficult to find or otherwise worth repairing. If your having to deal with troubles with your fuser assembly and you decide it’s time for you to start replacing items then its potentially just the perfect time to switch out the complete fusing unit because of the cost. Beneath you will see a url to obtain in a replacement fuser and a web page link to the illustrated fusing unit replacement instructions.

CopyStar CS-300i Fuser Replacement Procedure


Copystar CS300i Fuser Unit – 120 Volt (Genuine) – $169.95

Genuine 302K593060 Fuser Unit – 120 Volt for Copystar CS300i; Fuser Assembly / Unit – Genuine Kyocera Fuser Assembly; Copystar 302K593060 / 302H093030 / 2H093030
We will be happy to hear your thoughts

Leave a reply

Shopping cart