Nashuatec D2705 SC320 Error Code Maintenance Solutions
Majority of the time if you notice the Nashuatec D2705 SC320 Error Code the polygon motor is frequently locked up and possesses to much friction in regards to the motor bushing and polygon mirror pole. Down below you will find what the instruction manual has to say on the topic and a small amount of opinions of my own. Also, you will notice url links to shop for a new polygon motor and a connection to the replacement instructions right after the article content.
Ricoh AX06-0181 Polygon Mirror Motor (Genuine) – $129.95
from: Precision Roller
Service Manual Advice for the Nashuatec D2705 SC320 Error Code : Polygon motor error
-Definition- [B]
The polygon motor does not reach its operating speed within 10 seconds after
the polygon motor on signal, or the lock signal is not detected for more than 200
ms continuously during operation.
– Possible causes –
• Polygon mirror motor defective
• Poor connection between the polygon mirror motor driver and the BICU board
• BICU board defective
Note : The laser beam bounces off the polygon mirrors subsequently they should never be handled besides absolutely necessary. Moreover, if you do get them smudged or notice they are dirty, they are Significantly sensitive and can scuff with the slightest speck of dirt particles. Make use of softest, most clean towel you can come across to clean them off and don’t utilize minor force.
I personally tackle these all basically the in an identical way. I for starters duplicate the problem and listen to see if I can hear the motor start. If it isn’t really locked up, they generally tend to sound like a really noisy cooling fan. You can distinguish it how you prefer, however it is not ordinarily difficult to miss. Secondly, I remove the motor out, remove the polygon mirror from the motor bushing, take a alcohol damp que tip and clean up the inside of the motor bushing, clean off the post on the polygon mirror with alcohol, then oil the two portions with a little bit of thin oil. Lately, I’ve been using 3 n 0ne oil. I put it back together again and spin it somewhat to be sure that its totally free then put the machine together and try again.
- Now if it is still locked up before you put it back in the machine, then try the process over.
- If you still hear the sound then you can try the process again or order in a replacement motor.
- You can always, just order in the replacement motor if you don’t want to try this procedure.
- And if I do this operation and I get a call back in a few weeks or months then I just replace the motor.
In the photograph underneath you’ll check out a picture of a comparable motor. I’ve circled the item the holds the polygon mirror down. The black piece will turn so you can remove the polygon mirror assembly out of the motor bushing. Be sure you swivel the black section back into location once you reinstall the polygon mirror assembly, and just as before, be sure you do not touch the mirrors. Grab it near the base.
Click on the link below for removal and replacement instructions
Nashuatec D2705 Laser Motor Replacement Procedure
There are other factors that can this error, but 99% of the time this will take care of your problem.Â
Ricoh AX06-0181 Polygon Mirror Motor (Genuine) – $129.95 Genuine Ricoh AX06-0181 Polygon Mirror Motor; Motor – Genuine Ricoh Part; Mfr PNs: Ricoh AX05-0141, AX060181, AX050141, Savin AX06-0181, AX05-0141, AX060181, AX050141, Gestetner AX06-0181, AX05-0141, AX060181, AX050141, Lanier AX06-0181, AX05-0141, AX060181, AX050141 |
