Xerox Workcentre 3210 ADF Roller Replacement 130N01364, 130N01500
Xerox Workcentre 3210 ADF Roller Replacement Procedure 130N01364, 130N01500
Listed below, you will find the Xerox Workcentre 3210 ADF Roller Replacement Operation. Because we move more and more in the direction of scanning docs, I’ve observed and incline in the volume of papers being fed within document feeders. Differing producers specify different maintenance numbers regarding the roller and separation pad. I’d say whenever the roller is between 50,000 and 75,000 it more than likely needs to be swapped out in addition the separation pad rubber is rated between 25,000 and 50,000. Down the page, you will look at the illustrated replacement guidelines.
Xerox Workcentre 3210 ADF Roller Replacement tips
Indicators of old rollers are reduced pick up. The majority of folks note that they must somewhat shove the paper documents along for starters to get it started feeding in to the component and intermittent jamming comes about on a regular basis. Indications of a old pad tend to be numerous feeding or some like to call it, double feeding. When you notice signs of either one of such issues the best option is to upgrade these parts. In most cases if your having problems feeding, cleaning the rollers off slightly ought to get it back performing again for a short amount of time till you can get the items found. Multiple feeding is actually more annoying and is challenging to get it operating in the right way prior to the separation pad is changed out.
Xerox Workcentre 3210 Doc Feeder (ADF) Pickup / Feed Roller Assembly (Genuine)
Xerox Workcentre 3210 ADF Roller Replacement Procedure
1. Fully Open the Document Feeder Top Cover to expose the feed rollers.
2. Release the Bushing and rotate it until it reaches the slot, as shown below. Then lift the Pick Up Assembly out..
Xerox Workcentre 3210 ADF Separation Replacement Procedure
1. Remove the ADF pick up roller assembly
2. Either remove the white pad on top of the pad holder assembly or press in on either side of the bottom tabs and pull the whole separation pad holder assembly out and replace with the assembly. Make sure that the spring goes back in correctly. Sometimes they are stuck to the bottom of the old holder so make sure they get installed with the new holder.
There you have it. This job is pretty easy and has minimal cost.
Click on the link below to order in your Xerox Workcentre 3210 ADF Roller Replacement and Separation Pad Replacement Parts
Xerox Workcentre 3210 Doc Feeder (ADF) Pickup / Feed Roller Assembly (Genuine) – $34.95 Genuine 130N01364 Doc Feeder (ADF) Pickup / Feed Roller Assembly for Xerox Workcentre 3210; Doc Feeder Part – Genuine Samsung Part; Xerox 130N01364 / 130N01500 |
 Xerox Workcentre 3210 Doc Feeder Rubber (Genuine) – $49.95 Genuine 019N00566 Doc Feeder Rubber for Xerox Workcentre 3210; Doc Feeder Part – Genuine Xerox Part |
