Muratec MFX-3050 ADF Roller Replacement Procedure SA9701962C
Just below, there is the Muratec MFX-3050 ADF Roller Replacement Steps. As we move more and more in direction of scanning items, I’ve encountered and incline with the levels of paper being fed via document feeders. Various producers put differing maintenance rates with the roller and separation pad. I’d think that when the roller is between 50,000 and 75,000 it most certainly ought to be swapped out in addition the separation pad rubber is rated around 25,000 and 50,000. In the next paragraphs, you will locate the illustrated replacement suggestions.
Muratec MFX-3050 ADF Roller Replacement tips
Warning signs of worn rollers are less than ideal grab. Many people note that they must sort of push the pages along at first to get it started feeding in to the equipment and occasional jamming develops repeatedly. Indicators of a worn pad will be multiple feeding or some like to call it, double feeding. If you find indications of either of such issues your best choice is to upgrade these parts. Often when your having issues feeding, washing the rollers off a small amount ought to get it back working once more for a bit of time till you can get the items acquired. Multiple feeding is often worse and is hard to get it performing effectively prior to the separation pad is swapped out.
Muratec MFX-3050 Doc Feeder (ADF) Pickup / Feed Roller Assembly (Genuine)
Muratec MFX-3050 ADF Roller Replacement Procedure
1. Fully Open the Document Feeder Top Cover to expose the feed rollers.
2. Release the Bushing and rotate it until it reaches the slot, as shown below. Then lift the Pick Up Assembly out..
Muratec MFX-3050 ADF Separation Replacement Procedure
1. Remove the ADF pick up roller assembly
2. Either remove the white pad on top of the pad holder assembly or press in on either side of the bottom tabs and pull the whole separation pad holder assembly out and replace with the assembly. Make sure that the spring goes back in correctly. Sometimes they are stuck to the bottom of the old holder so make sure they get installed with the new holder.
There you have it. This job is pretty easy and has minimal cost.
Click on the link below to order in your Muratec MFX-3050 ADF Roller Replacement and Separation Pad Replacement Parts
Muratec MFX-3050 Doc Feeder (ADF) Pickup / Feed Roller Assembly (Genuine) – $34.95 Genuine Doc Feeder (ADF) Pickup / Feed Roller Assembly for Muratec MFX-3050; Doc Feeder Part – Genuine Samsung Part |
 Muratec MFX-3050 Doc Feeder Separation Pad Only (Genuine) – $6.95 Genuine G9601222 Doc Feeder Separation Pad Only for Muratec MFX-3050; Doc Feeder Part – Genuine Samsung Part – Also Works in the MP Tray Assembly Only in the Samsung SCX6345N, Xerox WorkCentre 4150S |
