Gestetner SP3200SF ADF Roller Replacement Procedure B273-9530, B2739530
Beneath, there is the Gestetner SP3200SF ADF Roller Replacement Remedy. Because we move more and more towards scanning docs, I’ve noticed and incline in the level of documents being fed by means of document feeders. A number of products define differing maintenance values relating to the roller and separation pad. I’d think in case the roller is between 50,000 and 75,000 it potentially should be changed additionally, the separation pad rubber is rated somewhere between 25,000 and 50,000. Beneath, you will acquire the illustrated replacement instructions.
Gestetner SP3200SF ADF Roller Replacement tips
Symptoms of worn out rollers are unsatisfactory pick up. Nearly all people note that they must sort of urge the paper documents along in the beginning to get it started feeding inside the component and sporadic jamming shows up repeatedly. Warning signs of a worn out pad are typically numerous feeding or some like to call it, double feeding. When you see signs and symptoms of either of such conditions your best choice is to change these sections. Usually if your having problems feeding, cleaning the rollers off a little bit ought to get it back operating again for a bit of time till you can get the components required. Multiple feeding is typically more serious and is challenging to get it functioning effectively till the separation pad is swapped out.
Gestetner SP3200SF Doc Feeder (ADF) Pickup / Feed Roller Assembly (Genuine)
Gestetner SP3200SF ADF Roller Replacement Procedure
1. Fully Open the Document Feeder Top Cover to expose the feed rollers.
2. Release the Bushing and rotate it until it reaches the slot, as shown below. Then lift the Pick Up Assembly out..
Gestetner SP3200SF ADF Separation Replacement Procedure
1. Remove the ADF pick up roller assembly
2. Either remove the white pad on top of the pad holder assembly or press in on either side of the bottom tabs and pull the whole separation pad holder assembly out and replace with the assembly. Make sure that the spring goes back in correctly. Sometimes they are stuck to the bottom of the old holder so make sure they get installed with the new holder.
There you have it. This job is pretty easy and has minimal cost.
Click on the link below to order in your Gestetner SP3200SF ADF Roller Replacement and Separation Pad Replacement Parts
