Xerox Phaser 3300MFP Low Heat Error MessageÂ
Below you will find repair advice for the Xerox Phaser 3300MFP Low Heat Error Message. Lots of things can cause this error, sudden power outage, accidental false reading, and other situations. Most the time just turning the machine off and on should take care of the problem. If it’s more serious then typically you will get a open heat message when the machine is turned back on. Below is some tips on how to resolve this particular problem. However, if you feel this repair is beyond your expertise or doesn’t fix your problem then I have provided links to order in a replacement fuser and at the bottom of the article you will find a link to the simple replacement instructions. 99% of the time, replacing the fuser takes care of these issues, rarely do you have to go to the power supply or other board on these machines.
Xerox Phaser 3300MFP Fuser Unit – 110 / 120 Volt (Genuine) – $139.95
from: Precision Roller
Troubleshooting the Xerox Phaser 3300MFP Low Heat Error Cycle Power
1. Turn the power off then back on.
2. Check the power source. Make sure the machine is plugged straight into a wall outlet.
3. Remove the fusing assembly and check the thermistor for debris built up on the contacts. Gently clean contact and make sure that when installed it rides on the top of the hot roller.
4. Check for continuity through the lamp and thermostats.
5. Replace the Fusing assembly. See the instructions in the link below. Â
Click on the link below for Fuser Removal Instructions
Xerox Phaser 3300MFP Fuser Replacement Instructions
There you have it. If you have a little technical skill this job shouldn’t be to hard to figure out. Now if you’ve read this and are like, I ain’t doing that, then click on the link below for the fuser replacement instructions. Given the age of these machines it might not be a bad idea to just replace the fuser.
Xerox Phaser 3300MFP Fuser Replacement Instructions
Click on the link below to order in your Xerox Phaser 3300MFP Fuser Replacement Part
Xerox Phaser 3300MFP Fuser Unit – 110 / 120 Volt (Genuine) – $139.95 Genuine 126N00265 Fuser Unit – 110 / 120 Volt for Xerox Phaser 3300MFP; Fuser Assembly / Unit – Genuine Samsung Fuser Assembly |
B01BI0ONC6/asa]
B01824ZCBM/asa]
B01BHSLJGC/asa]
B01BHSLQ92/asa]
