Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8001 Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8001 along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8001
E531 8001 Staple Motor (M9) error
Description :
Description After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Causes :
Staple Motor (M9) error
Solutions :
Remedy
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Remember, not every error is exactly the same. What fixes the Canon imageRUNNER 1750, 1740, 1730 Error Code E531 8001 one time might not solve it the next time. While the information above comes from the service manual and generally should get your machine up and running, sometimes other factors might be in play.
If you are reading this article and have experience with this error and would like to contribute please leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the issue then I will respond.
