Canon imageRUNNER 1750, 1740, 1730 Error Code E530 8002 Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750, 1740, 1730 Error Code E530 8002 along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750, 1740, 1730 Error Code E530 8002
E530 8002 Front Alignment Motor (M4) error
Description :
Description The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).
Causes :
Front Alignment Motor (M4) error
Solutions :
Remedy
1. Check the connector connection of the Staple Unit.
2. Check for open circuit of the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Remember, not every error is exactly the same. What fixes the Canon imageRUNNER 1750, 1740, 1730 Error Code E530 8002 one time might not solve it the next time. While the information above comes from the service manual and generally should get your machine up and running, sometimes other factors might be in play.
If you are reading this article and have experience with this error and would like to contribute please leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the issue then I will respond.
