Kyocera FS3040MFP and FS3140MFP C6030 Error Code

 

Kyocera FS3040MFP and FS3140MFP C6030 Error Code

Below you will find information on the Kyocera FS3040MFP and FS3140MFP C6030 Error Code along with a link at the bottom of the page to the fuser removal and replacement instructions. Also, on this page, you will find links to order in a replacement fuser if needed.

Kyocera FS3040MFP and FS3140MFP C6030 Error Code

Service Manual Information for the Kyocera FS3040MFP and FS3140MFP C6030 Error Code

6030 Broken fuser thermistor 2 wire
Description :
average AD value input from fuser thermistor 2 for 1.8 seconds is less than one. (Only when the detection temperature is 50°C or more.)
Causes :
Defective connector cable or poor contact in the connector.
Reinsert the connector. Also check for continuity within the connector cable. If none, remedy or replace the cable.
Fuser unit and engine PWB (YC506)
Deformed connector pin.
Defective triac.
Broken fuser thermistor 2 wire.
Fuser thermostat triggered.
Broken fuser heater wire.
Solutions :
Reinsert the fuser unit.
Replace the fuser unit.

Click on the link below for the fuser replacement instructions
Kyocera FS3040MFP, FS3140MFP, FS3540MFP Fuser Replacement

We will be happy to hear your thoughts

Leave a reply

Shopping cart