Dell 2130cn Pick Up Roller Removal Procedure

 

Illustrated Instructions for the Dell 2130cn Pick Up Roller Removal

Rated at 50,000 prints or 5 years as the rubber ages these pick up rollers will need to be changed at one point or another. Below you will find instructions on the Dell 2130cn pick up roller removal. Due to the fact these rollers sit underneath the drums they tend to get dirty. If I have feed problems in the tray or the paper fails to make it out of the tray I usually get a damp cloth and wipe down the roller. I dry the roller and try again. If the machine starts working then I typically get the roller on order and return when received. If you print off the configuration page in the reports menu you can see the page count to verify the print cycle. I’d say at this point the machines are over 5 years old so the rubber is getting dried out anyway and probably should be replaced.

G866F -N Dell 2130cn Pick Up Roller Main Tray

Dell 2130cn Pick Up Roller Removal Instructions
1. Remove the Tray 1.
2. Open the Front Cover
3. Remove the PHD Unit.
( I don’t have one of these in front of me but it might be done without removal of the Drum. I know on some of them they can and others it’s not as easy. The main thing I would be concerned about are the drum surfaces and the transfer belt on the front door. The belt and drums are very fragile so I would make sure my shirt pockets are empty and be careful not to drop anything on  them  or touch  them as they are photoconductive)
Note: Cover the drum of the PHD unit to avoid exposure to light. I wouldn’t worry about this too much. Unless you are slow as a snail. This procedure shouldn’t take to long. Just make sure you don’t sit it in direct sunlight. Putting it on a desk or in a shaded area for 5 minutes isn’t going to hurt it. If your worried then take a dry cloth or towel and cover it.
4. Release the hook shown in the picture below  on the left of the pick up roller holder, and move the  holder  to the left until it stops.

Dell 2130cn roller holder release
5. Release the groove on the  pick up roller  from the vertical pin mounted on the metal shaft  by sliding  the pick up roller to the left.

Dell 2130cn pick up roller removal
6. Close the front cover.
7. Remove the pick up roller from the metal shaft by rotating the pick up assembly 180 degrees. This can take a little patients. They don’t give you a lot of remove to maneuver.

Dell 2130cn roller removal

 

Click on the link below for buying options for the pick up assembly.

The fusing assembly is  rated at 50,000 prints like the roller, when the fuser gets near the end of it’s life it will display a Replace Fuser Now Message. Below is a link to purchase the fuser, pick up roller, and separation roller in one kit saving money and providing a more complete PM.

 

We will be happy to hear your thoughts

Leave a reply

Shopping cart