List of the Dell 1815dn Repetitive Defects
There is lots of rollers found in this machine and it’s given at one point or another something is going to stick to a roller or a roller will get a mark on it. Most the parts that have rollers in these machines are consumable parts so rather than call for service if you know what to look for you can save some money in repair cost. Below is the Dell 1815dn repetitive defects list along with a picture that identifies the parts in the machine. You measure the defects by taking the first mark on the page and measure down to the next mark. This will give you the diameter of the roller causing the issue. The interval does not necessarily match the circumference of the roller. At that point you can look at the list and identify what part needs replaced.
Dell 1815DN High Yield Toner (5,000 Yield) (OEM# 310-7945), Part Number RF223
Dell 1815 1815DN Printer UG297 110V Complete Fuser Assy
[one_third]Contaminated Roller[/one_third][one_third]Defect Measurement[/one_third][one_third_last]Description[/one_third_last]
[one_third]1 – Â OPC Drum[/one_third][one_third] Â 75.5mm / 2.97 inches[/one_third][one_third_last]White spot, Block spot[/one_third_last]
[one_third]2 – Â Charge Roller[/one_third][one_third]37.7mm / 1.48 inches[/one_third][one_third_last]Black spot[/one_third_last]
[one_third]3 – Â Supply Roller[/one_third][one_third]44.9mm / 1.767 inches[/one_third][one_third_last] Â Horizontal density band[/one_third_last]
[one_third]4 – Â Develop Roller[/one_third][one_third]35.2mm / 1.385 inches[/one_third][one_third_last]Horizontal density band[/one_third_last]
[one_third]5 – Â Transfer Roller[/one_third][one_third]47.1mm / 1.85 inches[/one_third][one_third_last]Black side contamination/transfer fault[/one_third_last]
[one_third]6 – Â Heat Roller[/one_third][one_third]77.8mm / 3.06 inches[/one_third][one_third_last]Black spot and fuser ghost[/one_third_last]
[one_third]7 – Â Pressure Roller[/one_third][one_third]75.4mm / 2.968 inches[/one_third][one_third_last]Black side contamination[/one_third_last]
