Fuser Removal Instructions for The HP Laserjet 2400, 2420, and 2430 Printer

 

Fuser  Removal on The HP Laserjet 2400, 2420, and 2430

Below is the instructions on the fuser  removal of the HP laserjet  2400 series printers. The main thing I can say here is to read the last comments after this article. When ever you replace the fusing assembly, make sure that you have a gear kit with you so completing the job can be done on the first or second trip out there.
Hp Laserjet 2400, 2420, 2430 Fuser Assembly – RM1-1535
 
[contentblock id=2]

 HP LaserJet 2400, 2420, 2430 Fuser Removal Instructions

Back CoverHP 2400 back cover removal
1. Open the rear output bin all the way by pressing the door down disengaging the door stops. All the way down the door should be at a 90 degree angle. Remove the two screws.

2. At the bottom of the back cover behind the dust cover door are two alignment tabs. Disengage those by pulling from the bottom and lifting the cover away from the machine.

I/O Cover
1. Pull right and lift away from machine.

Hp Laserjet 2400, 2420, 2430 Fuser Assembly – RM1-1535

1. Remove the fuser-cable cover by releasing one tab on the cover and then rotating the back of the cover toward theHP-2400-IO-cover center of the printer
2. Remove the duplex inlet guide by releasing the two tabs and pull it out towards you.
3. Disconnect the two cables on the right side and unclip the wire holder on side of frame securing the top cable.
4. Disconnect the power cable on the left and remove the four screws near the corners on the fuser.
5. Gently remove the fuser from the back of the machine.

HP 2400 series fuser removal picture

P3005 Shown Everything is very similar in the 2400

Ok that is how the  fusing unit  removal procedure. Hopefully with the instructions and pictures you were able to figure  it out. Now I’ve been replacing the gears right beside the fuser  when ever I install a new fuser  in these machines. A lot of times the gears wear with the  fusing assembly gear so when yo install a new fusing assembly  there tends to be more of a grinding sound coming from the rear right side of the machine. Below is a link to the purchasing a new fuser  and the gear assembly. You can see by the picture shown wear the gears go after you have the  fusing unit  out. They just unclip and pull out, then you just slide on the new ones. Just make sure you take not which one went wear before you remove the gears.
Hp Laserjet 2400, 2420, 2430 Fuser Assembly – RM1-1535



HP Laserjet P3015dn Printer, (CE528A)

Price: $1,294.99

26 used & new available from $95.00


HP M602n Wireless Color Printer

Price: $1,082.71

16 used & new available from $169.00


HP M602dn Wireless Monochrome Printer

Price: $1,950.24

17 used & new available from $185.00


[contentblock id=1]

We will be happy to hear your thoughts

Leave a reply

Shopping cart