Fuser Removal Instructions for the HP LaserJet P3015 Printer

 

Fuser  Removal in the HP Laserjet  P3015 Printer

In this article I’d like to discuss the fuser  removal in the HP P3015  Printer. By now I’m sure more and more of these machines are starting to have fuser related problems. I hope the instructions in the article below will help make this procedure as easy as possible. In these machines it can be a little bit more difficult than others. So read the instructions carefully.

$119.87
out of stock
3 new from $119.87
as of March 27, 2024 1:31 am
Amazon.com
$133.94
$144.94
in stock
4 new from $133.94
3 used from $110.00
as of March 27, 2024 1:31 am
Amazon.com
Last updated on March 27, 2024 1:31 am

Rear-door assembly
Unplug Machine and let sit for 10 minutes to cool.
1. Open the rear door.
2. Gently pull down on the door and lower the door until it is fully open.
3. Push up on the link arm to release it.
CAUTION: The link arm is under spring tension. Do not let the link arm snap back toward the
product when you release it.
4. Remove two screws.
5. Open the lower-rear door, and then release one tab.
6. Release one tab.
7. Rotate the bottom of the rear-door assembly away from the product.
8. Pull down on the rear-door assembly to remove it.
Right-rear cover
1. Slide the right-rear cover toward the inside of the product to release it.
2. Rotate the bottom of the cover away from the product, and then pull down on the cover to remove it.
Fuser ( RM1-6274-000CN )      
1. Duplex models only: Release two tabs on the duplex media-feed guide, and then slide the guide toward the back of the product to remove it.
Reinstallation tip Make sure that both tabs snap back into place when reinstalling the duplex media-feed guide.
2. Disconnect three connectors, and release one wire harness from the retainer.
3. Remove four screws.
4. Pull the fuser out of the back of the product.
CAUTION: To avoid damaging the fuser, the cartridge-door assembly must be closed before you remove the fuser.

Alright, Hopefully the fuser removal procedure described above was easy to understand and you were able to get the fuser in your machine replaced with out too many problems. Below is a link to purchase a new fuser if you haven’t done so yet. Like always, if you have any questions please send me a comment or email and I will help out as much as I can.

$119.87
out of stock
3 new from $119.87
as of March 27, 2024 1:31 am
Amazon.com
$133.94
$144.94
in stock
4 new from $133.94
3 used from $110.00
as of March 27, 2024 1:31 am
Amazon.com
Last updated on March 27, 2024 1:31 am

For More information involving Printer Repair and some articles I have written check out: http://blog.marketpoint.com/

We will be happy to hear your thoughts

Leave a reply

Shopping cart